Procom PCSD25T Guía de instalación descargar pdf (Pagina 6)

UNPACKING

1. Remove top inner pack

2. Tilt carton so that heater is upright.

3. Remove protective side packaging.

4. Slide heater out of carton.

5. Remove protective plastic wrap.

6. Unlock door handle and pull forward.

7. Remove log set by cutting plastic ties.

8. Carefully un-wrap log.

9. Check for any shipping damage. If stove or log is damaged, promptly inform your dealer where you bought the

heater.

PRODUCT IDENTIFICATION

WATER VAPOR: A BY-PRODUCT OF UNVENTED ROOM HEATERS

Water vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1) ounce

(30ml) of water for every 1,000 BTUs (.3kWs) of gas input per hour. An unvented room heater is recommended as a

supplemental heater (a room) rather than a primary heat source (an entire house). In most supplemental heat

applications, the water vapor does not create a problem. In most applications, the water vapor enhances the low

humidity atmosphere experienced during cold weather. The following steps will help insure that water vapor does not

become a problem:

1. Be sure the heater is the proper size for the application, including adequate combustion air and circulation air.

2. If there is high humidity, the dehumidifier may be used to help lower the water vapor content of the air.

3. Do not use an unvented room heater as the primary heat source.

Figure 1

1 2 3 4 5 6 7 8 9 10 11 ... 30 31

Sin comentarios

Procom PCSD25T Guía de instalación Pagina 6